This NEW framing system really gets to grips with easy wall mounting of printed display graphics - It offers greater freedom than wall pasting images and allows you to create attractive wall displays using unusual frame shapes - There are three basic profile types to suit particular demands. Front tensioning, side tensioning and a general profile for retro fit applications. Handyflex® is ideal for many in-store promotion wall areas and exhibition display applications.

The 10mm and the 20mm deep Aluminium/PVC flexible face tensioning system is available in Black, White or Silver Grey. It can be used for the mounting of small size A4 prints right up to gigantic 20m x 5m sizes.
The Handyflex® system can be installed directly onto site walls with a relatively minimum of effort.

Handyflex® can also be retrofitted to existing display areas and light boxes where one piece graphics are required, overcoming many of the restrictions in width or length of rigid materials.

This new product is extremely simple to install and to use. It is also very cost effective. It offers first class tensioning of printed graphic materials for wall display and exhibition purposes.

The Handyflex 'backless' framing system can be reused over and over again and provides a perfect, wrinkle free display. Plug and screw the pre-drilled and mitred sections to the wall, peg the face in position to overlap the aluminium. Remove the pegs as the tension strip is hammered into the aluminium profile, which tensions the faces as you go. Trim off the excess print from around the frame and the job is done.
Full instructions are provided and fitting is the same method regardless of print size.

We can produce the graphics, install the system if required and make change-outs Nation wide.

Handyflex grips most types of flexible materials and fabrics up to 650gms.

Artillus Illuminating Solutions Ltd
5 BELLMAN GATE, HOLCOT LANE,
SYWELL, NORTHANTS NN6 0BN
ENGLAND
Tel:++44 (0)1604 678410
Fax: ++44(0)1604 671335

Pictured above is a non illuminated 5m x 3.4m wall mounted print using the Handyflex frame with White PVC trim.

The picture below illustrates how the system works. A snap in PVC trim grips the printed fabric in the aluminium profile.

Both pictures show the use of the front profile, the one below is in Black and in the image to the right is in White.
The side profile gives a 'borderless' look but access is required to hammer the profile into the side frame after it has been wall mounted.

The Black or White PVC trim can be used for internal and external display. Whilst the Grey trim is recommended for internal use only.

GraphElite®
T5 Edge Lit Light Boxes

GraphElite®
CCFL and LED Light Boxes

CaseLite
Back Lit Light Boxes

Lumiwall®
Large Format
Flexible Face Back Lit

AllumiLite
Small Format
Flexible Face Back Lit

Postermatic
Scrolling Poster Cases

Handyflex
Wall Graphics Mounting System

TensionFlex
Frameless Graphics Wall Mounting System

Vitincom
Poster Displays

Snap Frames & Fixings
Posters and Display

Inoventi
Display System

Printed Graphics
Design and Production

Home